HVAC Design Port Hope

Contact us

Contact Form

Port Hope has heritage homes, lakeside properties and newer builds, and our team knows the area well, with our office in Campbellcroft. Our HVAC design in Port Hope gives you the plan before the equipment: calculated loads, a duct layout and the HVAC permit drawings your building department needs. We have been operating since 2011, we are fully licensed by the HRAI and BCIN registered for HVAC design work, and our team brings over 20 years of hands-on experience. The full process is described on our HVAC design page .


Request your Port Hope design

Contact us

Heat Loss Calculation in Port Hope

A heat loss calculation in Port Hope measures how much heat each room loses through walls, windows, roofs and air leaks, then works out heat gain the same way for summer. Heritage homes with original windows and stone or brick walls behave nothing like a new build with spray foam, and lakeside exposure adds wind to the picture. We size the furnace, heat pump or air conditioner from those figures instead of from square footage, which avoids oversized equipment that short cycles and leaves rooms uneven. Every HVAC design in Port Hope we complete begins with this step, and it is the one most often skipped when a system is simply replaced like for like.

Duct Design in Port Hope


Older Port Hope homes often have ducts that were added after the fact and squeezed in wherever they fit. A duct design in Port Hope starts from the load figures and works out the right size and path for every run, with registers placed to blend the air and returns that keep each room balanced. Our HVAC design in Port Hope shows exactly where each run goes, so you can see what a retrofit involves before anyone opens a wall. Homes in Garden Hill, Campbellcroft and the countryside around town often have longer runs and more exposed ductwork, which makes careful planning even more valuable.


A white air conditioning unit sits on a blue circuit board diagram with pipes, wiring, and industrial equipment surrounding i
Équipement HVAC extérieur incluant une pompe à chaleur et un ventilateur de traitement d'air montés à l'extérieur d'une résidence.

Permit Drawings and Code Compliance


Most permit applications for new homes and major renovations need mechanical calculations and drawings. We are BCIN registered for HVAC design work, and we prepare the HVAC permit drawings against the Ontario Building Code so they are ready for the building department. Because they come from the same design that sizes your equipment, there is no duplicate effort. See how this HVAC design in Port Hope fits into our HVAC design across Northumberland County .


Contact us

Speak with our design team

Contact us
Worker installing radiant floor heating tubing on subfloor with spacing clips.

HVAC Design Port Hope: What You Receive

  • Room-by-room load figures: Heating and cooling requirements for every space, including summer heat gain, ready to share with any installer.
  • Duct layout drawings: Run sizes, register positions and return paths shown on a clear plan.
  • Equipment sizing guidance: The capacity your home actually needs, so quotes can be compared fairly.
  • Ventilation plan: Fresh air provisions, including ERV or HRV placement where the project calls for it.
  • Permit-ready documents: Supporting calculations and HVAC permit drawings organized for your building department.
  • Code review: Mechanical details checked against the requirements the reviewer will look for.

Is Design-First Right for Your Project?

If you are building, adding space or replacing equipment, the answer is almost always yes, because a plan costs far less than a mistake inside a wall. An HVAC design in Port Hope is also useful when you want independent numbers before choosing a contractor, since the same plan can be priced by any qualified installer. Send us your drawings and we will tell you what the design involves.


Send us your building plans

Contact us